- Filter efficiency 99.997% at 0.3 microns
- Ideal for use in light duty laser making applications
- Removes particulates and chemicals from laser exhaust
- Supported with HEPA filter and reverse air flow technology
- BOFA AD350 Filtration System
- Power Cord
- Width: 22"
- Length: 20"
- Height: 33"
- Weight: 102 lbs
Exhaust Management Methods
During operation, laser cutters generate exhaust that may be hazardous to health. Always operate the Dremel LC40 Laser Cutter with proper exhaust ventilation and/or filtration, and always operate in a well-ventilated area. Consult with federal, state and/or local authorities and applicable homeowner or condominium associations to ensure compliance of ventilation and exhaust systems. The installer of the exhaust management system is responsible for complying with all codes, regulations and laws, including those for hazardous or noxious exhaust ventilation systems.
There are five options for managing the exhaust generated during the laser fabrication process. Consult the table below to determine an appropriate exhaust management method based the intended operating location of the Laser Cutter, the size of room where it will be operated, and the intended frequency and duration of laser fabrication. Methods A, B, and E involve discharging the exhaust outdoors, while Methods C and D use an air filtration system that can be used indoors with the laser cutter.
When venting the exhaust outdoors (methods A, B, and E), choose an exhaust location where it will not cause a public nuisance, and not less than the following distances: 10 feet from property lines; 10 feet from operable openings into buildings (e.g. windows, doors, air intakes); 3 feet from exterior walls and roofs; 10 feet above adjoining grade. The onboard fan (method A) may only be used if less than 10 feet of duct is used between the laser cutter and the outdoor exhaust location. If more than 10 feet of duct will be needed, use the external booster fan (method B).